Help me Write Essay

Mendelian Genetics – Introduction to Drosophila and Genetic

Laboratory 1 – Mendelian Genetics – Introduction to Drosophila and Genetic

basis of the Principle of Segregation in F2 progeny of a monohybrid cross.

In this lab we will become familiar with the fruit fly Drosophila melanogaster that is used for conducting various genetic crosses in the laboratory. We will examine some of the morphological features of Drosophila that show variation and set up a monohybrid cross to show Mendel’s principal of segregation. We will also set up a cross involving a sex-linked trait.

Because the Drosophila experiment will take 10 days per generation.

Introduction to Drosophila

We will practice handling and examining Drosophila fruit flies. We will follow the procedures from Mertens and Hammersmith – Investigation 1, with some important modifications. We will use the Carolina Formula 4-24 Instant Drosophila Medium. We will anesthetize flies by cooling 2 (to 2.5) minutes in freezer (no longer or else they die or become sterile) in a vial without food and keep them cool on ice packs rather than using a chemical anesthetic such as ether. Flies are cultured at 20-25°C in the incubators provided (these are preset at the required temperature and require no adjustment).

Also see: Mendel’s Principles and Contribution to Modem Biology

Techniques for handling Drosophila

Anesthetization of flies:

Flies must be anesthetized in order to keep them inactive during examination or while they are being transferred into culture vials for mating. You have been provided with plastic dishes with ice, plastic containers for ice water baths, plastic petri dishes and white filter paper.

Use the following procedure to anesthetize the flies:

1. Obtain a plastic dish with ice and place a petri dish with one piece of filter paper in it on the ice surface.

2. Shake the flies down into the bottom of the culture vial by tapping the vial, then remove the plug and quickly transfer the flies into an empty vial.

3. Insert the vial with the transferred flies into the freezer.

4. When the flies in the vial have stopped moving about 2 minutes (check them every 15 sec after 2 minutes), and then pour a few of them out onto the filter paper in the petri dish.

2

Do not leave flies in a freezer for more than a 2.5 minutes because they may die or become sterile!!!

5. Flies will normally remain anesthetized if kept on an ice bath or block.

Culture vial preparation:

1. Obtain clean culture vial and foam plug.

2. Add 1 small scoop of dry food to vial.

3. Add 1 small scoop of tap water to vial.

4. Add two or three (2 or 3) grains of dry yeast to the vial.

5. Dry off any water on inside exposed walls of vial with a Kim-wipe.

6. Place foam plug in the vial to keep wandering Drosophila out.

Setting up cultures:

1. Anesthetize flies.

2. Transfer flies to an empty vial with brush.

3. After the flies wake up they can then be added to the food vials.

4. Label vial with date and types of male and female flies used.

5. Subculture the mutant and wild stocks every one to two weeks; never keep the vials with

cultures longer than 3 weeks.

Setting up reciprocal crosses:

1. Clear adults from vials once pupal cases form. (Subculture if needed)

2. Collect virgin females within six to seven hours of clearing vials.

3. Place virgin females in vial with food. (Up to 8 per vial, based on availability)

4. Add males of other stock; try to wait before adding males so the females will be strong; use

slightly less males than females.

5. Label vials properly. Two vials for each reciprocal cross are recommended.

6. Clear adults when pupal cases appear. (Set up in another vial if desired.)

7. Wait for F1 to emerge and score.

8. Collect data on the first 100 Fl’s flies to emerge from each reciprocal cross.

9. Tabulate information on the Fl generation flies with regard to sex and phenotype for each

reciprocal cross.

10. If conducting testcrosses, then F1 virgin females need to be collected.

11. When setting up the F1 flies for the F2 generation set up a new labelled vial then add an equal number of F1 males and females. The female flies do not need to be virgins, because it does not matter if mating occurred before or after the flies are put into the new vials as this is a sibmating.

12. Once again, clear the adults when the pupal cases appear.

13. Collect data on the first 100 F2 generation flies to emerge from each reciprocal cross.

(14) Tabulate information on the F2 generation flies with regard to sex and phenotype for each reciprocal cross.

Keep records of your crosses in Table 1.2 on (page 9-new book) (page 8 old book), or you can

set up the information for in a MS Word file. Keep your records on the methods and data for

your crosses for the F1 and F2 generation to write up later on.

Fly Lab report is worth a 100 points. It should be made into a word document which you will need to upload to a Turn-it in link on Canvas. The link only takes one document, so make sure everything you need to include in the report is one single document.

We are using ether not freeze!!!

We are using ether not freeze!!!

We are using ether not freeze!!!

one chart one page,at least 10 pages

APA Style will be used in the Fly Lab Report. Both running head and in-text citations are needed. The font should be uniform. Choose either Times New Roman or Calibri as the font of your document. The font size can be 12 or 13. The title can be bolded on the same font sizes. Paragraph spacing should be double.Margins on all sides are necessary. The alignment should be justified. Page numbers should be present on the main section of the report.

Fly Lab Report Guide

Fly Lab report is worth a 100 points. It should be made into a word document which you will need to upload to a Turn-it in link on Canvas. The link only takes one document, so make sure everything you need to include in the report is one single document.

Formatting:

APA Style will be used in the Fly Lab Report. Both running head and in-text citations are needed. The font should be uniform. Choose either Times New Roman or Calibri as the font of your document. The font size can be 12 or 13. The title can be bolded on the same font sizes. Paragraph spacing should be double.  Margins on all sides are necessary. The alignment should be justified. Page numbers should be present on the main section of the report.

Cover Page:

The cover page should be double spaced, centered, and include the following information: a title, your name, instructor’s name, class name, and date.

Sections to the report:

There will be four sections in the report:

  1. Introduction:

Write a short background on fruit flies and introduce the theories that is necessary for the project. DO NOT list them out, discuss them in detail. Be sure to have correct in-text citations. You may include pictures or figures to further explain information. If pictures or figures are used, there must be a figure/picture number and a caption.

  1. Materials/Methodology:

All materials used in project should be included. In methodology, you should discuss how the experiment was set up and performed. This is where you should introduce the different crosses used in the project.

  1. Results:

Form tables and charts to display data collected in the experiment. You should be able to show observed values for your theories. YOU CANNOT HAVE RAW DATA AS YOUR RESULTS! The raw data should be included in an annex after the References page. All tables in Results Section should have a proper table number and title. After each table, there should be a short summary of the information presented in the table.

  1. Discussion

In the discussion, you should analyze the results from the experiment. You can refer to specific table numbers from the Results section and compare it with expected theoretical values for the theories introduced in the Introduction.

You can add a conclusion section to wrap up the conclusions of your report. Acknowledgement is another section that can be included.

 

 

References:

Your references should be on a separate page. At least five references(all from valid and reliable sources), at least two should bepeer- reviewed articles.

 

An annex is required to include your raw data.