Concrete slab for a single storey, 25mx25m factory.

Module 3 – Assessment Task 10 – Activity 10.1 – Materials Fact Sheet

Materials and Testing Portfolio

Your worksite is pouring a concrete slab for a single storey, 25mx25m factory. You must produce a materials and testing portfolio to brief clients, contractors and management of the processes and impacts of this job. Your materials and testing portfolio must include:

Materials Fact Sheet

Delivery Fact Sheet

Materials Testing Plan & Result Report Sheet.

The Materials Fact Sheet must include:

1. Suitability of material for the job

2. Properties of the material

3. Structural requirements and suitability of material to the job

4 Fire resistance rating, serviceability and cost effectiveness of the material

5 Short and long-term degradation factors of materials

6 Alternative materials, in comparison with materials specified

7 Australian Standards key to working with the material

8 Environmental impacts of the material

9 Allowable tolerance of the material

10Tolerances for installing and assembling the material

11Checklist for checking the work performed against the Australian Standards

Module 3 – Assessment Task 10 – Activity 10.2- Delivery Fact Sheet

Materials and Testing Portfolio

Your worksite is pouring a concrete slab for a single storey, 25mx25m factory. You must produce a materials and testing portfolio to brief clients, contractors and management of the processes and impacts of this job. Your materials and testing portfolio must include:

Materials Fact Sheet

Delivery Fact Sheet

Materials Testing Plan & Result Report Sheet.

Task 10.2 – Delivery Fact Sheet

The Delivery Fact Sheet must include:

1. List of organisational procedures for the acceptance, safe handling and storage of material

2. Communication plan for communicating organisational procedures on site

3. Work instructions for handling materials correctly and safely on site using appropriate equipment and safe work practices

4. Work instructions for storing materials in accordance with manufacturer specifications and in compliance with the relevant Australian standards

5. List of limitations and effects of transportation on materials and components

6. List of potentially damaging circumstances

7 List of possible defects, and how to identify them

8 Actions to be taken in the case of defects caused by incorrect installation, application or placement

9 List of recycling options for excess materials

10 The locations and other factors influencing how the material must be stored

Task 10.3 – Material Testing Plan & Results Report Sheet

Material testing plan must include:

1. Testing specification for the material

2 Expected results for compliant materials

3 Expected results for defective materials

4. Checklist for a visual defect check

5 List of external tests, if required

6 Actions to take on defective materials

Results Report Sheet must include:

1 Procedures for reporting test results

2 How results are recorded and stored

3 How/when reports are periodically evaluated
Uploaded materials